LockState LS-L500-RB Bedienerhandbuch PDF herunterladen (Seite 3)

Inside Knob

Inside Lever

wood screw

screws

Mounting

Plate

Screws

IC wire

a. Half-close the door to lay the latchbolt against the door frame.

Mark the position of faceplate as an indication.

Place the strike against the door frame and mark it's erimeter.

Be sure the center of strike is perfectly aligned with the center of faceplate.

b. Drill a ø25.4mm (1") hole with 13mm (1/2") depth on the center of strike outline.

Then use the chisel to scrape out the door frame for 1.6mm (1/16") deep within

your pencil mark.

Ensure to chisel deep enough to allow the strike lay flush with the frame surface.

c. Insert the strike and tighten it with screws.

Note : please use “tapping screws” for metal door.

6. Install Keypad Assembly

5. Install Strike

a b c

a. Place the leverset/knobset against keypad with tailpiece in vertical position

inserted through cam of the latch.

Tailpiece should be turned to vertical.

Tailpiece

Outside Lever

Outside Knob

b. Pass the IC wire over the latch to the interior side of door.

IC wire

7. Install Inside Mounting Plate

Pass the IC wire through the wire hole on the

mounting plate and fix the mounting plate with

screws. If outside lock assembly is lopsided,

please loosen the screws to adjust it's position

and tighten the screws again.

8. Install Receiver Module

a. Remove the battery cover (push it up and pull it out).

b. Connect the IC wire and ensure the turn piece is horizontal, so that the tailpiece

is able to engaged with the inside lever/knob. Then attach receiver module to the

door with screws. It's optional to use the attached wood screw.

(Wood screw only for wood door)

c. Insert 4 (AA) 1.5V alkaline batteries and put the battery cover back to the

receiver module.





Turn

Piece

Receiver

Module

Battery

Cover

a b

1 2 3 4 5 6 7

Kommentare zu diesen Handbüchern

Keine Kommentare

LockState LS-L500-RB Bedienerhandbuch Seite 3

Kommentare zu diesen Handbüchern