Pass Code & Function Set up
■
Remark
■
1. We recommend to use alkaline battery in order to stabilize the power supply.
2. Do not mix alkaline battery with regular zinc-carbon ones or mixed brands.
3. Do not use any chemical liquid or lubricating oil with additives to clean the lock
body, it will damage the surface or even mainboard.
4. If there is any problem of the product, please contact your local retailer and send
back the product to us for repair or replacement.
12.Unlock the door
12-1 The lockset will be unlocked by key or pressing User Code on keypad from
outside or by interior turn-button.
12-2 To unlock the door on the keypad, enter the User Code and then press the
Programming/Enter button.
13.Lock the door
The lockset will be locked by key or pressing Programming Button on keypad from
outside or by interior turn-button.
14.To Activate / Deactivate Auto-Locking Function
14-1 The lockset will automatically lock itself within 10~99 seconds when this function
is programmed.
14-2 This function is not preset at the beginning; it can be set if needed.
14-3 The preset delay-time is 30 seconds; you can adjust the period as you want.
14-4 Please repeat the same programming steps to cancel Auto-Locking function when
needed.
15.Toggle Mute On/Off
15-1 You will hear beep sounds when pressing keypad, programming or operating
errors. It can be turned off if needed.
15-2 LED Illumination is still functioning when it's in mute. For there will be no any
warning alarm, we suggest not to mute the beeper if it's not necessary.
15-3 Motor operating sound cannot be muted.
16.Code Protection Function
The system will shut down if entering unauthorized codes over 5 times.
The System will be operative again after 45 sec.
17.Illumination
The LED Keypad will light up when pressing any button for ease of operating in the
dark.
1. It should be under unlock status while programming.
2. Please change default Programming Code (0000) and User Code (1234) before
function set up when first time operation base on safety consideration.
3. LED flashes orange slowly while programming. LED flashes green twice with 2 long
beeps when correct input. LED flashes red 3 times with 3 beeps when incorrect
input.
(You need to wait for 6 seconds or press programming button
when incorrect input, then the system will be operative again.)
4. Each programming step should be done within 6 seconds.
5. You can lock/unlock this product by either key or keypad.
Please refer to the following programming table for function set up.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern